Cleaning the Feed Dog

Remaining threads under the stitch plate must occasionally be removed.

CAUTION

Electronically Driven Components

Risk of injury near the needle and the hook.

  1. Raise the presser foot.
  2. Switch the machine off and disconnect it from the power supply.
  1. Switch the machine off and disconnect it from the power supply.
  2. Remove the presser foot and the needle.
  3. Lower the feed dog.
  5. Push the unlocking lever (1) to the right and remove the bobbin cover (2).
  7. Loosen both screws and remove the stitch plate.
  9. Clean the feed dog with the brush.
  11. Refit the stitch plate. Insert both screws and tighten them.
  12. Insert the bobbin cover.
  13. Raise the feed dog.
  14. Insert a needle.
  15. Attach the presser foot.
  16. Connect the machine to the mains power and switch it on.