Attaching the Slide-on Table

  Video

  1. Raise the needle.
  2. Raise the presser foot.
  3. Release the adjustable legs on the slide-on table. Make sure that the adjusting screws are not turned out too far.
  5. Slide the table over the freearm under the needle and foot to the right until it engages on the right side.
  7. Fully extend the legs of the table.
  8. Adjust the height by turning the screw at the feet. Ensure the table is flat and supported on the surface below without raising it above the freearm.
  10. To remove the slide-on table, pull the slide-on table away to the left beneath the presser foot and the needle.
  12. Lock the legs into place for storage.